Interlock switch Shuts off 24 V DC power line when the top cover is opened. Setting of physical offset 2. Disconnect the 13 connectors from the Main Board Assy. Remove the two screws, and remove the Top Cover. Open the duplex cover. Physical offset can be configured.
|Date Added:||9 September 2012|
|File Size:||67.95 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Remove the five screws, and remove the Gear Unit.
Toner attracts to the magnet sleeve since it is Disengage the two hooks from the back of the cassette, and remove the Separation Roller. Remove the two screws, and remove the metal plate. Click on the [OK]. Disconnect the two connectors.
トナーカートリッジ | 製品安全データシート（（M）SDS） | 製品情報 | エプソン
Part Names Table Open the Front Cover. Disconnect the connector from the Main Board Assy, and release the cable from the Clamp. Don’t have an account?
This manual also for: Chapter 4disassembly And Assembly 4. Right cooling fan motor Cools the interior of machine. Lights Flashes on and off at intervals of 0. Secure the Bottom Plate by pressing it down.
Download Epson LP-SN printer driver & Resettter | Driver Epson
If no Eraser lamp does Poor connection Reconnect the connector cable properly. Remove the Paper Feed Unit upward. Remove the gear from the Transfer Roller.
Remove the Controller Cover in the direction of the arrow. A vertical black line appears on the lp-s300j. The value can be Horizontal Polygon motor Drives the polygon mirror. Disconnect the connector from the Eraser Lamp. Pull out the bushing. Remove the paper cassette. Page 4 Location of Safety Equipment Safety Safety-related Symbols Indicates an operating or maintenance procedure, practice or condition that, if not strictly observed, would result in injury or loss of life.
While pressing the tabslide the Unlock Holder 2. For the operational procedure, follow the instructions shown by the program. After turning the power off for both the printer and computer, connect them with a parallel or USB cable.
Insert the grooves of the Separation Roller over the guide pins of the Cassette. The paper which passed through the fuser unit turns on the actuator epeon sensor in the fuser unit, and is led by the guide comprised of the rear cover, frame and the FD cover guide, finally reaching the upper FD roller.
for epson lp s300
Clean the surface of the roller located at the position shown below using a cloth When finished, put the tab back into place. Areas of the printed image are missing. Indicates an operating or maintenance procedure, practice or condition that, if not strictly observed, could result in injury or loss of life. List of Printer Messages Table Disconnect the three connectors from the Main Board Assy.